Answer:
A wind turbine harnesses the energy generated from moving air patterns, which activate large blades that turn a turbine to create electricity?
Explanation:
Wind turbines work on a simple principle: instead of using electricity to make wind—like a fan—wind turbines use wind to make electricity. Wind turns the propeller-like blades of a turbine around a rotor, which spins a generator, which creates electricity.
Wind is a form of solar energy caused by a combination of three concurrent events:
1.The sun unevenly heating the atmosphere
2.Irregularities of the earth's surface
3.The rotation of the earth.
Wind flow patterns and speeds vary greatly across the United States and are modified by bodies of water, vegetation, and differences in terrain. Humans use this wind flow, or motion energy, for many purposes: sailing, flying a kite, and even generating electricity.
The terms "wind energy" and "wind power" both describe the process by which the wind is used to generate mechanical power or electricity. This mechanical power can be used for specific tasks (such as grinding grain or pumping water) or a generator can convert this mechanical power into electricity.
A wind turbine turns wind energy into electricity using the aerodynamic force from the rotor blades, which work like an airplane wing or helicopter rotor blade. When wind flows across the blade, the air pressure on one side of the blade decreases. The difference in air pressure across the two sides of the blade creates both lift and drag. The force of the lift is stronger than the drag and this causes the rotor to spin. The rotor connects to the generator, either directly (if it’s a direct drive turbine) or through a shaft and a series of gears (a gearbox) that speed up the rotation and allow for a physically smaller generator. This translation of aerodynamic force to rotation of a generator creates electricity.
Hey peoples I mean boi who answered this question "nice explanation but you never actually answered the question :( The answer is gas.
pls hurry
Which of the following elements must be present on a fertilizer label?
iron
potassium
copper
manganese
Answer:The answer is Potassium!
Explanation: This is true because each label should tell you about the available amount of a certain element. The standard order is Nitrogen-Phosphorus-Potassium. They are referred to by their standard abbreviations in the periodic table. One problem with fertilizer labels are that they are only required to disclose the amounts of macronutrients (or Nitrogen-Phosphorus-Potassium.)
Answer:
Potassium on edge.
Explanation:
Which statement correctly describes the section symbol?
A. The section is on sheet 4 in folder C-3
B. The section number 4 is on sheet number C-3
C. The section number C-3 is on sheet number 4
D. The section number 4 has a sub-section number C-3
B. The section number 4 is on sheet number C-3
Explanation:
mark above answer BRILLIANT
Which option identifies the type of model that will best represent all aspects of the design in the following scenario?
Nico is currently designing a new television. It is going to be very thin, so it is important for his model to demonstrate all of its dimensions.
technical
orthographic
sketch
isometric
Answer:
The correct option is;
Orthographic
Explanation:
An orthographic projection is a technique of displaying an object that has three dimensions in a two-dimensional format, such that the image drawn of the original object is detailed and clear. Designers, architects, technical related artist and engineers, make use of orthographic projection to aid the understanding of the manufacturer of the details specific to the product, that the manufacturer is to create.
Answer:
isometric
Explanation:
correct on edge the other guy lied
I NEED ANSWER'S ASAP PLEASE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Which option explains why the sealing agents are an issue in the following scenario?
Jeremy is a civil engineer who has been called in to repair a leak in a fluid power system that supplies water to several houses. The engineer who originally designed the system placed the sealing agents in hard-to-reach places.
Sealing agents were not meant for use in this type of system; couplings are installed for this purpose.
Sealing agents were placed where the filter is usually located.
Sealing agents are made of rubber, cork, or metal and need to be replaced regularly.
Sealing agents are made of eco-friendly materials that are difficult to properly position in hard-to-reach places.
Answer:
Sealing agents are made of eco-friendly materials that are difficult to properly position in hard-to-reach places.
Explanation:
Can someone make me a chair on onshape DONT be rude I’m sick of wasting my points and getting them back now the points are going to be a little lower now :/ if your not going to be nice don’t even comment at ALL!!! This is due TODAY!!! :( plz and send me the link so the teacher doesn’t think I got someone’s I’ll give you brainlist and points like make me something like the example picture
Answer:
Honestly if you mostly need help are you allowed to ask your peers??? if I struggle there were plenty of kids I would ask and they would help
When tires are underinflated, it leads to ______.
IT can cause tires to overheat, which can lead to premature wear, tread separation and blowouts
Answer:
less efficiency and poor gas mileage
Explanation:
What is mechanical energy? Name at least two objects that are in motion when mechanical energy moves a car
Answer:
Explanation:
A moving car possesses mechanical energy due to its motion (kinetic energy). A moving baseball possesses mechanical energy due to both its high speed (kinetic energy) and its vertical position above the ground (gravitational potential energy).
When a car moves, the mechanical energy is generated. As a car moves, the brakes and the springs present inside the engine of the car are in motion with the car. Mechanical energy is the total energy of an object.
What is Mechanical energy?Mechanical energy is the sum total of the kinetic energy, or energy of motion, and the potential energy, or energy stored in a system in a particular position of all the parts.
Objects possess mechanical energy if they are in motion and if they are at some position relative to a zero potential energy position like a brick held at a vertical position above the ground or at zero height position. A moving car possesses mechanical energy due to its motion i.e., kinetic energy.
A moving vehicle possesses mechanical energy in the form of kinetic energy, a compressed spring possesses mechanical energy in the form of potential energy.
Learn more about Mechanical energy here:
https://brainly.com/question/12319302
#SPJ2
3 facts about the Tokyo Skytree tower
Answer:
Skytree is the tallest tower in the world
Skytree is not the tallest structure in the world
Nearly 8,000 people were expected at the opening
Pairing form with function, Skytree will serve as a TV and radio broadcast tower
Save
Select the correct answer
Bruce wants to present to his client an architectural drawing that shows the exact details of the living room, kitchen, bedroom, and stairs in
relation to other areas of the house. Which type of architectural drawing should Bruce use?
electrical plan
wall section in a detail drawing
cutting plane view
plan view in a general plan
OE
section viewin a general plan
Reset
Next
Answer:
I believe it D.
Explanation:
not sure I will see after the test.
Im taking it right now.
Answer:
i think its E
Explanation:
You are a planning aide on a team and are given the assignment of researching the historical significance and original blueprints of certain houses. What is your assignment supporting?
historical rejuvenation
historical significance
historical renovation
historical preservation
Which sentence best describes the entire Energy career cluster? O Energy careers involve the generation, transmission, and distribution of power that can be used for O Energy careers involve the generation, transmission, and distribution of energy that can be used fo O Energy careers involve turning fuel into power that can be used for energy Energy careers involve turning fuel into energy that can be used for power.
Answer:
B
Explanation:
i took the test.
Answer:
B
Explanation:
Why did the Tacoma bridge collapsed?
Answer:
The arodynamics of how much power the wind it was being taking to is and it kept twisting
Explanation:
You should provide feedback to at least two other students’ posters and brochures. Comment on what they did well and what they could have done better. Review the feedback that your projects received. How could you improve each one?
Answer:
u need to comment on two of your classmates posters lol
Explanation:
u just need to comment and see what ppl said about yours, insta is papibrenna :p
Answer:
I'm guessing it's the same thing as the other answer. I'd say you need to just look for any flaws on other people's posters and brochures, then look for some good things, you like about them and leave your personal feedback on what you think.
Explanation:
What does the Intake do?
Answer:
It creates airflow in the engine
Explanation:
Answer:
intakes gas and stuf.............