Que. 1. Gallium has 2 naturally occuring Isotopes with mass numbers 69 & 71 respectively. What is the percentage abundance of both Isotopes if their relative atomic mass is equal to 70.59 Amu (Atomic mass Unit)​

Answer:

The volume of [tex]\rm O_2[/tex] required would be [tex]120\; \rm cm^{3}[/tex], assuming that both the pentane and the [tex]\rm O_2\![/tex] in this question are ideal gases and are under the same temperature and pressure.

Explanation:

Balance the equation for the reaction:

[tex]\rm ?\; C_{5}H_{12} + ?\; O_2 \to ?\; CO_{2} + ?\; H_{2}O[/tex].

Start by setting the coefficient of the molecule with the largest number of atoms to [tex]1[/tex].

In the combustion of alkanes (including pentane,) consider setting the coefficient of the alkane to [tex]1\![/tex].

[tex]\rm 1\; C_{5}H_{12} + ?\; O_2 \to ?\; CO_{2} + ?\; H_{2}O[/tex].

Number of carbon atoms among the reactants: [tex]5[/tex].

Number of hydrogen atoms among the products: [tex]12[/tex].

By the conservation of atoms, there would need to be the same number of carbon and hydrogen atoms (along with the oxygen atoms) among the products.

Hence, the coefficient of [tex]\rm CO_2[/tex] would be [tex]5[/tex] while the coefficient of [tex]\rm H_2O[/tex] would be [tex]12 / 2 = 6[/tex].

[tex]\rm 1\; C_{5}H_{12} + ?\; O_2 \to 5\; CO_{2} + 6\; H_{2}O[/tex].

There would be [tex]5 \times 2 + 6 \times 1 = 16[/tex] oxygen atoms among the products. Also by the conservation of atoms, there would be the same number of oxygen atoms among the reactants.

Hence, the coefficient of [tex]\rm O_2[/tex] would be [tex]16 / 2 = 8[/tex].

[tex]\rm 1\; C_{5}H_{12} + 8\; O_2 \to 5\; CO_{2} + 6\; H_{2}O[/tex].

The ratio between the coefficient of [tex]\rm O_2[/tex] and [tex]\rm C_{5}H_{12}[/tex] in the balanced equation is:

[tex]\displaystyle \frac{n({\rm O_2})}{n({\rm C_{5}H_{12}})} = \frac{8}{1} = 8[/tex].

In other words, it would take eight [tex]\rm O_2[/tex] molecules to react with one [tex]\rm C_{5}H_{12}[/tex] molecule.

Assume that both [tex]\rm O_2[/tex] and [tex]\rm C_{5}H_{12}[/tex] are ideal gases. Under the same temperature and pressure, the volume of the two gases would be proportional to the number of molecules in each gas:

[tex]\displaystyle \frac{V({\rm O_2})}{V({\rm C_{5}H_{12}})} = \frac{n({\rm O_2})}{n({\rm C_{5}H_{12}})} = \frac{8}{1} = 8[/tex].

In other words, it would take [tex]8\; \rm cm^{3}[/tex] of [tex]\rm O_2[/tex] to react with [tex]1\; \rm cm^{3}[/tex] of [tex]\rm C_{5}H_{12}[/tex] under these assumptions. It would then take [tex]8 \times 15\; \rm cm^{3} = 120\; \rm cm^{3}[/tex] of [tex]\rm O_2\![/tex] to react with [tex]15\; \rm cm^{3}\![/tex] of [tex]\rm C_{5}H_{12}\![/tex].

Answer:

Nitrogen oxides are used in the production of nitric acid, lacquers, dyes, and other chemicals. Nitrogen oxides are used in rocket fuels, in the nitrification of organic chemicals, and in the manufacture of explosives.

Explanation:

Answer:

Answer: Atoms of chlorine (CI) and magnesium (Mg)

Answer: Atoms of chlorine (CI) and magnesium (Mg)is your answer

Answer:

vegetables and salt

Explanation:

The ideal temperature for fermenting vegetables is between 18⁰-22⁰C. Within this range, the bacteria do their best work, giving high levels of lactic acid. The naturally occurring bacteria on fruits and vegetables is called lactobacillus. These bacteria convert the sugar to lactic acid, which is what gives that characteristic tangy/sour taste.

Answer: The hydroboration of an alkene occurs in TWO CONCERTED STEP which places the boron of the borane on the LESS SUBSTITUTED carbon of the double bond. The oxidizing agent then acts as a nucleophile, attacking the electrophilic BORON and resulting in the placement of a hydroxyl group on the attached carbon. Thus, the major product of the hydroboration oxidation reaction DOES NOT follow Markovnikov's rule.

Explanation:

Hydroboration is defined as the process which allows boron to attain the octet structure. This involves a two steps pathway which leads to the production of alcohol.

--> The first step: this involves the initiation of the addittion of borane to the alkene and this proceeds as a concerted reaction because bond breaking and bond formation occurs at the same time.

--> The second step: this involves the addition of boron which DOES NOT follow Markovnikov's rule( that is, Anti Markovnikov addition of Boron). This is so because the boron adds to the less substituted carbon of the alkene, which then places the hydrogen on the more substituted carbon.

Note: The Markovnikov rule in organic chemistry states that in alkene addition reactions, the electron-rich component of the reagent adds to the carbon atom with fewer hydrogen atoms bonded to it, while the electron-deficient component adds to the carbon atom with more hydrogen atoms bonded to it.

Answer: d. have the silicon-oxygen tetrahedron as their structural unit.

Explanation:

Silicates are anions that have both Oxygen and Silicon as the basis of their structure. These two form a tetrahedron type structure that enable them to be useful for a whole lot of things.

Silicates are very abundant on Earth as they comprise around 95% of the Earth's crust as well as the upper mantle which explains why they are mostly found in igneous rocks.

Explanation:

here's the answer to your question

double arrow just mean that it's a reversible process, and the reaction can go back and forth.

Answer:

The equilibrium shifts right to produce more SO3 molecules.

Explanation:

The equilibrium law states that when a system encounters a disturbance like a temperature, concentration, or pressure modifications, it will react to restore a new state of equilibrium.  

Adding a reactant such as oxygen (O2) will shift the reaction in the direction of the product, on the basis of the equilibrium law. Therefore, the equilibrium will move toward the product side.

Answer:

B. Protons and Neutrons

Answer:

Option"B" is correct.

MARK ME BRAINLISTS

Answer:

I think it's answer would be A

Answer:

soluble because all compounds containing K are soluble

Explanation:

Most metal hydroxides are insoluble. However, alkali metal hydroxides (such as KOH and NaOH) are very soluble.

In the case of KOH, the K cation is attracted to the electronegative oxygen on water. The OH anion is capable of hydrogen bonding to the water. (Notice how OH⁻ is simply the deprotonated form of water.)

The compound KOH is soluble insoluble, because all compounds containing K are insoluble insoluble, because all compounds containing OH- are in soluble soluble, because all compounds containing K are soluble soluble, because all compounds containing OH- are soluble insoluble, because KOH is insoluble

Alkalis are bases which are soluble in water. The basic alkalis are as follows:

Mg(OH)2 is insoluble in water.

In conclusion, KOH is a soluble base

Learn more about alkalis:

https://brainly.com/question/25317545

Answer:

The solvent molecules bump into the solid more often

Explanation:

Increasing the temperature makes a solid dissolve faster because the solvent molecules bump into the solid more often.

If we heat the solvent, the average kinetic energies of its molecules increase. Hence, the solvent is able to dislodge more particles from the surface of the solute. Thus, increasing the temperature increases the solubilities of substances. For example, sugar and salt are more soluble in water at higher temperatures.

The temperature of the solvent is another factor that affects how fast a solute dissolves. Generally, a solute dissolves faster in a warmer solvent than it does in a cooler solvent because particles have more energy of movement.

Learn more about solvent here https://brainly.com/question/25326161

#SPJ2

Answer:

0.19875

Explanation:

nFe2O3=0.099375

nFe=2nFe2O3=0.19875

Answer:

0.0111moles

Explanation:

as moles = mass/ mr(16+1+1)

so 0.2g / 18

gives you 0.111moles

hope this helps :)

Answer:

In physics, a frame of reference, or reference frame, is a perspective that one uses to determine if an object is moving.

For example, when you see a ball roll down a street, you can tell the ball is moving because the frame of reference is the streets, whatever may be on the side of the roads, or the Earth

Answer:

1)Or

d.Sublimation

2)

b.iodine is the solute and alcohol is solvent

3)

a.compostion of solute

Answer:

1) a) centrifugation

OR

b) sublimation

2) a) iodine is the solute and alcohol is solvent

3) a) concentration of soLute

Answer:

NAD

Explanation:

mark me brainlist please

Answer:

They lose energy which is used to form ATP

Answer:

im a just achild

Explanation:

Answer:

c

Explanation:

0.5dm³

follow me if you want

Answer:

2H2S (g) + 3O2 (g) = 2H2O (l) + 2SO2 (g)

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

[tex]\boxed{\pmb{\green{\sf{2H_{2}S(g) + 3O_{2}(g)\dashrightarrow 2H _{2}O(l)+2SO_{2}(g)}}}}[/tex]

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

Answer:

J

Explanation:

Heat is measured in Joules (J)

Answer:

Movement of water from the area of high concentration of solute to the area of low concentration of solute.

Explanation:

Diffusion can be defined as the movement of gas molecules from a region of high concentration to a region of lower concentration until an equilibrium is attained or reached. This mixing of gas molecules in the liquid or gaseous state is due to their kinetic energy of random motion i.e without requiring bulk motion.

This ultimately implies that, diffusion is a phenomenon through which gas molecules in either a gaseous or liquid state spread out in response to a concentration gradient, which is simply the difference in concentration of the gases across a space.

During diffusion, molecules move from areas of high concentration to areas of low concentration. Also, diffusion does not require energy to move molecules.

Hence, the process of diffusion can be described as movement of water from the area of high concentration of solute to the area of low concentration of solute.

A solute can be defined as a substance that is typically dissolved in a liquid solvent such as water, coffee, tea, etc., to produce a solution.

Answer:

Mechanism

explanation:

have a great day!

Answer:

don't know

Explanation:

try it your self

try it your self

try it your self

try it your self

try it your self

try it your self

Answer:

rubbing the ruler transfers electrons from the clothe to the ruler now the ruler has excess electrons and it is negatively charged... electrons will move away from the ruler leaving a positive charge on the tissue near the ruler so they attach

I hope this helps

Answer:

Frequency of spinal trait in the population = 0.11

Explanation:

Given:

Total spineless trait = 600

Number of spinal trait = 80

Find:

Frequency of spinal trait in the population

Computation:

Total population = Total spineless trait + Number of spinal trait

Total population = 600 + 80

Total population = 680

Frequency of spinal trait in the population = Number of spinal trait / Total population

Frequency of spinal trait in the population = 80 / 680

Frequency of spinal trait in the population = 0.11

Answer:

The answer is in the explanation.

Explanation:

The KHP is an acid used as standard in titrations to find concentration of bases as NaOH.

The reaction that explain this use is:

KHP + NaOH → KNaP + H2O

where 1 mole of KHP reacts per mole of NaOH

That means, at equivalence point of a titration in which titrant is NaOH, the moles of KHP = Moles of NaOH added

With the moles of KHP = Moles of NaOH and the volume used by titrant we can find the molar concentration of NaOH.

The moles of KHP are obtained from the volume and the concentration as follows:

Volume(L)*Concentration (Molarity,M) = moles of KHP

If the concentration is more or less than 0.100M, the moles will be higher or lower. For that reason, we need to know the concentration of KHP but is not necessary to be 0.100M.

Answer:

C. Molecules

Explanation: Water is a compound that conatins molecules hydrogen and oxygen.

Answer: Atoms

Explanation: