Answer:
0.0111moles
Explanation:
as moles = mass/ mr(16+1+1)
so 0.2g / 18
gives you 0.111moles
hope this helps :)
Describe how a constant volume calorimeter can be used to measure the heat transferred from a burning piece of coal to cool water.
thank you <3
Answer:
A Calorimeter is a device used to measure the amount of heat involved in a chemical or physical process.
Explanation:
Ex- when an exothermic reaction ( accompanied by or requiring absorption of heat)occurs in solution in a calorimeter, the heat produced by the reaction is absorbed by the solution increasing its temperature.
- When an endothermic reaction (Heat evolving reaction) occurs, the heat required is absorbed from the thermal energy of the solution, decreasing its temperature.
A burning piece of coal which is releasing heat due to its combustion and is transferred to water.
Mark as Brainliest ;)
what is the reactant(s) in the chemical equation below
3CO(g) + Fe2O3(s) 2Fe(s) + 3CO2(g)
Answer:
the reactants are carbon dioxide ,iron, oxygen
9.0 mol of pure ammonia gas was injected into a 3.0 L flask and allowed to reach equilibrium according to the equation 2 NH3(g) = N2(g) + 3 H2(g). The equilibrium mixture was analyzed and found to contain 3.0 mol of hydrogen gas. Calculate the value of the equilibrium constant.
NOExplanation:
I DONT KNOW MATE
A compound was found to contain 90.6% lead (Pb) and 9.4% oxygen. What is the empirical formula for this compound?
Answer:
the answer is 47.9 and ik because I just had that question
The empirical formula of the compound is O₄Pb₃.
What is the empirical formula?
An Empirical system is the chemical system of a compound that offers the proportions of the elements gifted within the compound however not the real numbers or arrangement of atoms. This would be the lowest complete variety ratio of the elements within the compound.
Amount of lead (Pb) = 90.6%
⇒and amount of oxygen = 9.4%
taking the whole number ratio
o = 4
Pb = 3
∴ ⇒O: Pb=4:3
O4Pb3 answer.
Learn more about empirical formula here:-https://brainly.com/question/1603500
#SPJ2
(answered on edge)
Calculate the percent by mass of each element.
%N = 35 %
%H = 5.0 %
%O = 60 %
Answer:
N=35%. so 35/100*7 =2.45%
H=5.0 so 5/100*1=0.05%
o=60% so 60/100*8=4.8%
ASAP
Which of the following gases will have the highest rate of effusion at a given temperature?
Cl2
He
O2
Ne
Answer:
chlorine Will be at highest
A toaster has a resistance of 28 Ω and is plugged into a 110 V circuit. Using the GRASS method, what current is measured?
Answer:
The current of the toaster is 3.93A
Explanation:
Using the GRASS method:
G: Given: The information that is given is that we have 28Ω of Resistance and 110V of voltage.
R: Required: We need to find the current measured.
A: Action: We can use Ohm's law that relates resistance, voltage and current in the equation:
V = R*I
Or:
I = V/R
Where I is current in A, V is voltage = 110V and R is resistance = 28Ω
S: Solve:
I = 110V / 28Ω
I = 3.93A
S: Statement:
The current of the toaster is 3.93Aprocess which take place when litimus paper turns white when dropped into a chlorine water
Answer:
It is called bleaching oxidation process.
what is the name of this organic molecule
Answer:
C2H4 Ethylene
Explanation:
Hope it helps! :)
list four quantum no. that defines energy state of the electron in hydrogen along with their possible values and explain their significance in terms of orbitals?
What is the molecular geometry of a molecule made of two atoms that share one pair of electrons and have no lone electrons pairs?
trigonal pyramidal
linear
trigonal planar
bent
Answer:
linear
Explanation:
Actually I consulted various sources too and that was the most sought answer,I just decided to answer you before studying it too
During an experiment the students prepared three mixtures A)Starch in water B) Sodium chloride solution C) Tincture of Iodine. i) Students observed a visible beam of light through mixture A. Why? ii) Tincture of Iodine did not show Tyndall effect . Explain reason. iii) How can you relate particle size to Tyndall effect?
The question requires a good knowledge of the meaning of Tyndall effect or scattering of light by false solutions in chemistry
The student observed a beam of visible light through mixture A because A exhibits Tyndall effect
Tincture of Iodine does not show Tyndall effect because its solution consists of particles less than 1 nanometer in solution.
A solution may be classified as a true solution or a false solution. A true solution consists of particles which are less than 1 nanometer in solution. A true solution does not scatter visible light.
A false solution, on the other hand consists of particles larger than 1 nanometer and does scatter visible light.
Starch in water is an example of a false solution or colloid hence it exhibits Tyndall effect. The scattering of visible light by a solution is known as Tyndall effect.
Tincture of iodine and sodium chloride in water are all true solutions hence they do not scatter visible light.
https://brainly.com/question/23487849
2. Low-density polyethylene, used to make plastic films, is
made by the radical polymerization of ethene, and is one of
the hardest plastics to recycle. It gets its name
A. from the process by which it's polymerized.
B. because of the way the chains pack like spaghetti, close
and tight.
C. from the spaces left between chains when the polymer is
formed.
D. because it's strong but flexible.
Answer:
from the spaces left between chains when the polymer is
formed.
Explanation:
Polyethylene polymer may be of high or low density. Whether the polymer is of high or low density depends on the arrangement of the polymer chains.
If the polymer chains are close together such that the resultant polymer is crystalline with chains packed closely, we have high density polyethylene.
On the other hand if the chains are not close together and there are spaces left between chains when the polymer is formed, then we have low density polyethylene.
Hence, low density polyethylene gets its name from the spaces left between chains when the polymer is formed.
Answer: it gets its name (from the process by which it's polymerized). Therefore the correct option is A.
Explanation:
Polyethylene is a type of plastic which is made by the polymerization of its monomers (ethene). The most common monomers are derived from petrochemicals. The monomers simply join together to form the polymers which has the same empirical formula as the monomer, but is of a higher molecular mass.
There are two main types of polyethylene, these include:
--> Low density polyethylene: when ethene is subject to a high temperature of about 250°C and pressure above 1500atm, together with traces of oxygen ( as an initiator), it polymerizes to polyethylene. The polyethylene obtained by the above method is called a low density polyethylene. It has the most long- and short-chain branching of any form of polyethylene, resulting in its lower density. Therefore its name is gotten from the process by which it's polymerized
--> High density polyethylene: this is prepared at a lower temperature and pressure by using catalysts.
what is true about solubility
Explanation:
Solubility is defined as a property of solutes by virtue of which they get dissolved in a favorable solvent. The solute can only be dissolved in any suitable solvent up to a limit at a given temperature. This is a characteristic of the the solute-solvent pairing.
3. What would be the freezing point for a 5.7 molal aqueous sucrose (C12H22O) solution? The freezing
point depression constant for water = 1.86°C/m. Show your work.
Answer:
- 10.6° C
Explanation:
Given that,
In the aqueous sucrose solution,
Molality of the solution (m) = 5.7
Freezing point constant (K) = 1.86
To find,
The freezing point of the solution = ?
Method:
To find its freezing point, we will first find out if the solute demonstrates an electrolyte or not.
In case it is not, the van't Hoff factor i.e. ration of particles' concentration denoted by (i) would be taken as 1. So,
ΔT(change in temperature) = i * m * K (putting the given values)
= 1 * 5.7 * 1.86
= 10.6° C
Thus, the freezing point equals to 0 - 10.6° C = -10.6° C.
hii pls help me to balance the equation and state the symbols thanksss
Explanation:
2Fe (s) + 3Cl2 (g) = 2FeCl3 (s)
The boiling points of diatomic halogens are compared in the table.
Boiling Points of Diatomic
Halogens
Molecule
Boiling Point
F2
-188 °C
Cl2
-34 °C
Br2
59 °C
12
184°C
Which of the following statements best explains the trends in boiling points?
The atomic size increases down the group, and this decreases the strength of the intermolecular forces.
The total number of electrons decreases down the group, and this decreases the strength of the intermolecular forces.
The total number of electrons increases down the group, and this increases the strength of the intermolecular forces.
The chances of forming a permanent dipole increases down the group, and this increases the strength of the intermolecular forces.
Which of the following statements best explains the trends in boiling points?
A. The atomic size increases down the group, and this decreases the strength of the intermolecular forces.
A is incorrect
B. The total number of electrons decreases down the group, and this decreases the strength of the intermolecular forces.
B is incorrect
C. The total number of electrons increases down the group, and this increases the strength of the intermolecular forces.
C is correct
D. The chances of forming a permanent dipole increases down the group, and this increases the strength of the intermolecular forces.
D is incorrect
The boiling point increase down a group because the total number of electrons increases down the group, and this increases the strength of the intermolecular forces. Hence option C is correct.
What is boiling point?Boiling point of a substance is the temperature at which the substance changes from its liquid state to vapour state. Boiling point of a molecule or compounds depends on the bond type, molecular weight, temperature and pressure.
For ionic compounds, boiling point will be higher since ionic bonds are stronger than covalent compounds. There is a periodic trend for the physical properties such as boiling point for elements in periodic table.
Down a group, the number of electrons increases and the atomic size also as well as the ionic character increases down a group . These two facts leads to higher intermolecular attraction, thus more temperature have to applied to weaken the bonds.
Higher temperature to be applied means the boiling point of the substance is higher. Therefore, boiling point down a group increases because of the higher intermolecular attraction as said in option C.
To find more about boiling point, refer the link below:
https://brainly.com/question/2153588
#SPJ1
(True or false) Two or more atoms combine to form a molecule ____
Answer:
false tjytyjiy
Explanation:
cnruujrkyrryyrkkurk
I need help on this question asap!
You are in a lab and you use 11.50 g of Na(s) to react with Cl(g). Below is the reaction that happens from this.
Na + Cl2 → NaCl
Your percent yield is 95%. From this info what is the actual yield?
Answer:
27.79 g to the nearest hundredth.
Explanation:
2Na + Cl2 ---> 2NaCl
Using the molar masses , the theoretical yield is:
46 g of Na yields 46 + 35.5*2 g NaCl
46 g ---> 117 g NaCl so
11.5 g ----> 117 * 11.5 / 46 g NaCl
But, as the yield is 90%
the actual yield is 0.95 * 117 * 11.5 / 46
= 27.79 g.
Usually scientists do not specialize and study one aspect of the
natural world, but will focus on many aspects to understand
why and how things happen.
TRUE
FALSE
Is it possible to prepare chlorine in lab without application of heat?
Answer:
i think it will explode
can u plz solve n send me
I will give u branist, rate u 5 star,give u a like and I will also follow u
Answer:
5.ethanol and carbon dioxide
6.it contains ethyl alcohol which can be effective at killing viruses and bacteria
Write the relation of M3 with its multiples
Explanation:
HI friends good morning
Cuales son los tipos de yemas
Matty told Harriet that, later that same day, he was going to try to convince her to change her attitude toward the nutritional merits of doughnuts. Based on research findings regarding persuasion, how effective is Matty's strategy?
Answer:
The correct answer is - not very effective; forewarning tends to reduce the effectiveness of an attitude change
Explanation:
The strategy of forewarning or warning before attempting any change in the psychology of an individual is found to be less effective. The subject sees a forewarning seen as a warning that a person is going to attempt to make changes in the attitude of a person about a particular thing or situation.
As a result, the person is ready to defenses up with regard to that idea of persuasion which Builds up defenses for the situation. Therefore, the effect of persuasion is reduced on the person.
Thus, Matty's strategy is not very effective; forewarning tends to reduce the effectiveness of an attitude change
write down the uses of periodic table।
Answer:
the uses of periodic table is we can classify the elements in different groups.I think.
Answer:
the list is endless so those are some of them but I am sure there are more.
Explanation:
everyone feel free to add
Question 10 of 10 A certain seed is surrounded by a sticky coating. It is fairly dense and does not float in water. How is this seed most likely spread?
A. It is dispersed by the wind, and it sprouts after it falls to the ground
B. It drops to the bottom of a body of water, where it sprouts.
C. It attaches to the fur of an animal, and it sprouts after it falls from the animal's fur.
D. Animals eat it, and it is deposited in their waste.
Elements in the same period Question 7 options: A) form bonds with the same type of elements. B) have the same number of protons. C) have the same number of valence electrons. D) have the same principal quantum number.
D is the answer .. I have send u pic also
write the electronic configuration of the first 20 element
When an acid or base is placed in water, it breaks apart into charged particles called...
A.atoms
B.ions
C.indicator
D.molecules
Answer:
B: Ions.
Explanation:
It breaks into two particles when placed into water: A positive ion and a negative ion.
